SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2004MONTANA VAN PASSENGERREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEMREPAIR INSTRUCTIONSINFLATABLE RESTRAINT INSTRUMENT PANEL MODULE REPLACEMENTINSTALLATION PROCEDURE
2004 Pontiac Montana Van Passenger

Installation Procedure

2004 Pontiac Montana Van PassengerSECTION Installation Procedure
    Fig 1: Locating Instrument Panel Inflatable Restraint Module Components
    GM260611Courtesy of GENERAL MOTORS CORP.
  1. Install the inflatable restraint I/P module (1) to the vehicle.
  2. Install the inflatable restraint I/P module bolts (5).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the inflatable restraint I/P module mounting fasteners (4).

    Tighten:  Tighten fasteners to 10 N.m (89 lb in).

  4. Install the pigtail harness clips on the module to the I/P carrier bracket.
  5. Install the electrical connector to the I/P compartment lamp and install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.