Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2004MONTANA VAN PASSENGERREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEMREPAIR INSTRUCTIONSINFLATABLE RESTRAINT FRONT END SENSOR REPLACEMENTINSTALLATION PROCEDURE
2004 Pontiac Montana Van Passenger
Installation Procedure
2004 Pontiac Montana Van PassengerSECTION Installation Procedure
- Install the front end sensor to the vehicle.
- Install the 2 integral bolts that retain the front end sensor to the frame front crossmember.
Tighten: Tighten the bolts to 8 N.m (71 lb in).
- Connect the sensor electrical connector (2) to the front end sensor.
- Install the CPA to the sensor electrical connector.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.