Quick Lookups: Fluids

2004 Pontiac Montana Van PassengerSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil w/o Rear AC 7.00 OZS. 0.2 L PAG 46 S
Air Cond Compressor Oil w/Rear A/C 8.00 OZS. 0.23 L PAG 46 S
Air Cond Refrigerant Front 1.70 LBS. 0.77 KG R-134a S
Air Cond Refrigerant Rear 2.20 LBS. 0.99 KG R-134a S
Automatic Transmission Fluid FWD Complete Overhaul 10.00 QTS. 9.46 L Automatic Transmission Fluid DEXRON VI Refer to TSB No. 04-07-30-037C, Date of Issue: April 11, 2007. S
Automatic Transmission Fluid FWD Pan Removal and Replacement 7.40 QTS. 7 L Automatic Transmission Fluid DEXRON VI Refer to TSB No. 04-07-30-037C, Date of Issue: April 11, 2007. S
Brake Fluid N/A N/A DOT 3 Brake Fluid S
Differential Gear Oil Rear 2.10 QTS. 1.98 L VERSATRAK Fluid S
Engine Coolant Rear,w/Climate Control 11.90 QTS. 11.26 L 50/50 mixture of DEX-COOL and clean, drinkable water After refill, the level must be checked. Add enough engine coolant so that the fluid is within the proper operating range. S
Engine Coolant w/Air Cond 9.60 QTS. 9.08 L 50/50 mixture of DEX-COOL and clean, drinkable water After refill, the level must be checked. Add enough engine coolant so that the fluid is within the proper operating range. S
Engine Oil w/Filter 4.00 QTS. 3.78 L API - SAE 5W-30 Use oil that meets GM Standard GM6094M. For areas of extreme cold, where temperatures fall below -20Deg.F (-29Deg.C), it is recommended a SAE 5W-30 synthetic oil or a SAE 10W-30 oil. Both will provide easier cold starting and better protection for your engine at extremely low temperatures. S
Fuel Tank Optional/Extended 25.10 GALS. 95.01 L S
Fuel Tank Standard/Regular 19.50 GALS. 73.81 L S
Power Steering Fluid N/A N/A GM Power Steering Fluid S
Transfer Case Fluid 1.20 QTS. 1.13 L VERSATRAK Fluid S
Windshield Washer Fluid N/A N/A Optikleen Windshield Washer Fluid Follow the Manufacturer's Instructions for the mixture ratio. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.