Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2004MONTANA VAN PASSENGERREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2004 Pontiac Montana Van Passenger

Installation Procedure

2004 Pontiac Montana Van PassengerSECTION Installation Procedure

Fig 1: View Of Memory Seat Control Module

GM740757

Courtesy of GENERAL MOTORS CORP.

Slide the module into the mounting bracket and push until the module is fully seated.

Fig 2: Locating Electrical Connectors

GM740755

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors.
Install the drivers seat.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9 in SIR.
Calibrate the seat. Refer to Memory Seat Calibration Procedure .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.