SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2004MONTANA VAN PASSENGERREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMREPAIR INSTRUCTIONSROLLER BRACKET REPLACEMENT - LOWERREMOVAL PROCEDURE
2004 Pontiac Montana Van Passenger

Removal Procedure

2004 Pontiac Montana Van PassengerSECTION Removal Procedure
  1. Remove the front edges of the sliding door inner trim panel in order to gain access to the sliding door lower roller bracket bolts.
  2. Mark the location of the sliding door lower roller bracket to the sliding door with a grease pencil.
  3. Support the sliding door.
    4. Fig 1: View Of Sliding Door Catch
    GM319980Courtesy of GENERAL MOTORS CORP.
  4. Remove the sliding door catch with the reinforcement channel bolt at the sliding door lower track.
    5. Fig 2: Locating Sliding Door Bracket Bolts
    GM319985Courtesy of GENERAL MOTORS CORP.
  5. Remove the sliding door lower roller bracket bolts.
  6. Remove the sliding door lower roller bracket from the lower track.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.