Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2004MONTANA VAN PASSENGERREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSEATSSEAT SYSTEMREPAIR INSTRUCTIONSSEAT SWITCH REPLACEMENT - POWERINSTALLATION PROCEDURE

2004 Pontiac Montana Van Passenger

Installation Procedure

2004 Pontiac Montana Van PassengerSECTION Installation Procedure

Fig 1: View Of Front Seat Adjuster Switch

Courtesy of GENERAL MOTORS CORP.

Connect the adjuster switch electrical connector.
Install the adjuster switch to the finish cover.
Install the finish cover to the seat adjuster.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the finish cover screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Connect the front seat pretensioner electrical connector.
Connect the front seat SIR module electrical connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.