Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSPONTIAC2004MONTANA VAN PASSENGERREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSENTERTAINMENT SYSTEMREPAIR INSTRUCTIONSSPEAKER REPLACEMENT - REARINSTALLATION PROCEDURE

2004 Pontiac Montana Van Passenger

Installation Procedure

2004 Pontiac Montana Van PassengerSECTION Installation Procedure

Connect the electrical connector to the rear radio speaker.

Fig 1: View Of Rear Radio Speaker Assembly

Courtesy of GENERAL MOTORS CORP.

Install the rear radio speaker (1):
1. Insert the tabs into the lower slots.
2. Push the upper tab into the slot on the liftgate (2).
Install the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate in Body Rear End.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.