Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Seat Assembly
A seat control adjustment switch is fitted to the outside of each seat frame. This switch assembly provides independent control of the seat-back recliner angle, front and rear cushion height (up and down movement) of the seat along with forward/rearward movement.
During seat adjustment, the drive motors will stop operating at end of travel via an internal thermal cut-out switch, even if the seat adjustment switch is held on.
The eight-way position switch is disabled during automatic movement requested by operation of the EZ-entry function. The switch will be enabled once the automatic movement is completed or cancelled. The eight-way position switch is monitored by the module during automatic movement, and if the switch is operated, the automatic movement will be cancelled and the seat will enter the manual mode.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.