Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2004AZTEK AWD V6-3.4L VIN EREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHSERVICE AND REPAIRPOWER WINDOW SWITCH REPLACEMENT - RIGHT FRONT
2004 Pontiac Aztek AWD V6-3.4L VIN E
Power Window Switch Replacement - Right Front
2004 Pontiac Aztek AWD V6-3.4L VIN ESECTION Power Window Switch Replacement - Right Front
POWER WINDOW SWITCH REPLACEMENT - RIGHT FRONT
REMOVAL PROCEDURE
1. Remove the front door window switch plate from the front door trim panel using a small flat-bladed tool at the front of the power window control plate.
2. Disconnect the electrical connector from the front door window control switch.
3. Remove the front door window control switch plate from the front door trim panel.
4. Remove the front door window control switch (1) from the front door window switch plate using a small flat-bladed tool.
INSTALLATION PROCEDURE
1. Install the front door window control switch (1) into the front door window switch plate pressing into place until fully seated.
2. Connect the electrical connectors to the front door window control switch.
3. Install the front door window control switch plate to the front door panel pressing into place until fully seated.
REMOVAL PROCEDURE
1. Remove the front door window switch plate from the front door trim panel using a small flat-bladed tool at the front of the power window control plate.
2. Disconnect the electrical connector from the front door window control switch.
3. Remove the front door window control switch plate from the front door trim panel.
4. Remove the front door window control switch (1) from the front door window switch plate using a small flat-bladed tool.
INSTALLATION PROCEDURE
1. Install the front door window control switch (1) into the front door window switch plate pressing into place until fully seated.
2. Connect the electrical connectors to the front door window control switch.
3. Install the front door window control switch plate to the front door panel pressing into place until fully seated.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.