Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2004AZTEK AWD V6-3.4L VIN EREPAIR AND DIAGNOSISTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGTIRE PRESSURE MONITOR (TPM) - RESET (CALIBRATE)
2004 Pontiac Aztek AWD V6-3.4L VIN E
Tire Pressure Monitor (TPM) - Reset (Calibrate)
2004 Pontiac Aztek AWD V6-3.4L VIN ESECTION Tire Pressure Monitor (TPM) - Reset (Calibrate)
Tire Pressure Monitor Reset Procedure
Important: After resetting, the TPM system requires up to 8 km/h (5 miles) of flat, smooth road, straight line driving in each of the 4 speed ranges to complete the calibration process. For further information, refer to Tire Pressure Monitor Description and Operation. If the TPM system does not reset, refer to Driver Information Center (DIC) Switch(es) Inoperative.
Using the DIC
1. Set all tire pressures to the recommended kPa/psi.
2. Turn ON the ignition, with the engine OFF.
3. Press the MODE button until LOW TIRE PRESSURE HOLD SET TO RESET is displayed.
4. Press and hold the SET button until a chime sounds and TIRE PRESSURE RESET is displayed and a chime sounds 3 times.
5. release the SET button and TIRE PRESSURE NORMAL is displayed.
Important: After resetting, the TPM system requires up to 8 km/h (5 miles) of flat, smooth road, straight line driving in each of the 4 speed ranges to complete the calibration process. For further information, refer to Tire Pressure Monitor Description and Operation. If the TPM system does not reset, refer to Driver Information Center (DIC) Switch(es) Inoperative.
Using the DIC
1. Set all tire pressures to the recommended kPa/psi.
2. Turn ON the ignition, with the engine OFF.
3. Press the MODE button until LOW TIRE PRESSURE HOLD SET TO RESET is displayed.
4. Press and hold the SET button until a chime sounds and TIRE PRESSURE RESET is displayed and a chime sounds 3 times.
5. release the SET button and TIRE PRESSURE NORMAL is displayed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.