Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2004AZTEK AWD V6-3.4L VIN EREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING MOUNTED CONTROLS TRANSMITTERSERVICE AND REPAIR
2004 Pontiac Aztek AWD V6-3.4L VIN E
Steering Mounted Controls Transmitter: Service and Repair
2004 Pontiac Aztek AWD V6-3.4L VIN ESECTION Service and Repair
Steering Wheel Control Switch Assembly Replacement
Removal Procedure
1. Caution: Refer to SIR Caution in Service Precautions.
Disable the SIR System.
2. Remove the steering wheel.
3. Remove the retaining screws (2, 3) from the steering wheel rear bezel.
4. Remove the steering wheel rear bezel (1).
5. Disconnect the electrical connector.
6. Insert a small, blunt-ended tool into the access hole in the back of the steering wheel. Push the switch out of the steering wheel.
Installation procedure
1. Connect the electrical connector.
2. Align the switch to the opening in the steering wheel.
3. Push the switch into the steering wheel.
4. Install the steering wheel rear bezel (1).
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the retaining screws (2, 3) to the steering wheel rear bezel.
Tighten the screws to 3 Nm (27 inch lbs.).
6. Install the steering wheel.
7. Enable the SIR System.
Removal Procedure
1. Caution: Refer to SIR Caution in Service Precautions.
Disable the SIR System.
2. Remove the steering wheel.
3. Remove the retaining screws (2, 3) from the steering wheel rear bezel.
4. Remove the steering wheel rear bezel (1).
5. Disconnect the electrical connector.
6. Insert a small, blunt-ended tool into the access hole in the back of the steering wheel. Push the switch out of the steering wheel.
Installation procedure
1. Connect the electrical connector.
2. Align the switch to the opening in the steering wheel.
3. Push the switch into the steering wheel.
4. Install the steering wheel rear bezel (1).
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the retaining screws (2, 3) to the steering wheel rear bezel.
Tighten the screws to 3 Nm (27 inch lbs.).
6. Install the steering wheel.
7. Enable the SIR System.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.