Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2004AZTEK AWD V6-3.4L VIN EREPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSSERVICE AND REPAIRMIRROR FACE REPLACEMENT
2004 Pontiac Aztek AWD V6-3.4L VIN E
Mirror Face Replacement
2004 Pontiac Aztek AWD V6-3.4L VIN ESECTION Mirror Face Replacement
MIRROR FACE REPLACEMENT
REMOVAL PROCEDURE
CAUTION: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
1. Place your fingers as far as possible behind the mirror face toward the center of the back.
2. Remove the mirror face from the mirror housing with sufficient force to disengage the snap-locks on the mirror motor.
3. Remove the mirror face from the mirror housing.
4. Disconnect the heated mirror electrical connectors if equipped.
INSTALLATION PROCEDURE
1. Connect the heated mirror electrical connectors if equipped.
2. Position the mirror face to the mirror motor.
3. Install the mirror face to the mirror motor with the palm of the hand on the center of the glass, pressing in until fully seated.
4. Inspect the mirror for proper operation.
REMOVAL PROCEDURE
CAUTION: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
1. Place your fingers as far as possible behind the mirror face toward the center of the back.
2. Remove the mirror face from the mirror housing with sufficient force to disengage the snap-locks on the mirror motor.
3. Remove the mirror face from the mirror housing.
4. Disconnect the heated mirror electrical connectors if equipped.
INSTALLATION PROCEDURE
1. Connect the heated mirror electrical connectors if equipped.
2. Position the mirror face to the mirror motor.
3. Install the mirror face to the mirror motor with the palm of the hand on the center of the glass, pressing in until fully seated.
4. Inspect the mirror for proper operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.