Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2004AZTEK AWD V6-3.4L VIN EREPAIR AND DIAGNOSISBODY AND FRAMEFENDERFRONT FENDERSERVICE AND REPAIRFENDER SOUND INSULATOR REPLACEMENT - FRONT
2004 Pontiac Aztek AWD V6-3.4L VIN E
Fender Sound Insulator Replacement - Front
2004 Pontiac Aztek AWD V6-3.4L VIN ESECTION Fender Sound Insulator Replacement - Front
Fender Sound Insulator Replacement - Front
Removal Procedure
1. Remove the front fender liner. Refer to Front Fender Liner Replacement (Service and Repair) .
2. Remove the front fender insulator from the stud, by pulling off.
3. Remove the front fender insulator from the inner fender.
Installation Procedure
Important: The front fender insulator must be kept near the flange of the front fender wheel opening to avoid interference with the front door edge.
1. Install the front fender insulator to the stud in the inner fender, pressing into place until fully seated.
2. Install the front fender liner. Refer to Front Fender Liner Replacement (Service and Repair) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.