SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1997GRAND PRIX GTP, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (BODY CONTROL MODULE)REMOVAL & INSTALLATIONBODY CONTROL MODULE (BCM)REMOVAL & INSTALLATION
1997 Pontiac Grand Prix GTP, 4D Sedan

Removal & Installation

1997 Pontiac Grand Prix GTP, 4D SedanSECTION Removal & Installation
WARNING: This page is about a different car, the 1997 Buick Regal and 1997 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Remove left instrument panel insulator. Disconnect BCM electrical connectors. Push BCM up, and pull bottom of BCM away from and out of mounting bracket slot. Remove BCM from vehicle. See Fig 1 . To install, reverse removal procedure.

Fig 1: Removing BCM
G97I28231Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.