Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U1255, Loss Of Class 2 Serial Data Fault (General): Notes
BCM receives a vehicle security powertrain status message from Powertrain Control Module (PCM). DTC U1255 will set when BCM does not receive this message within one minute of ignition switch being switched to RUN position. BCM will illuminate vehicle security warning light. If conditions for malfunction no longer exist, history DTC will clear after 100 consecutive ignition cycles. DTC U1255 will also clear when scan tool is used to clear codes.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.