Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U1096, Instrument Panel Class 2 Source Id 60: Notes
BCM receives a state of health message from module whose source ID is has learned. DTC U1096 will set when BCM does not receive a state of health message from Instrument Panel Cluster (IPC). No driver warning message will be displayed.
Under all fault conditions, ignition switch must be cycled from OFF to RUN position before a current code will change to a history code. A current DTC U1096 will change to a history code receives a state of health message. If conditions for malfunction no longer exist, history DTC will clear after 100 consecutive ignition cycles. DTC U1096 will also clear when scan tool is used to clear codes.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.