SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1997GRAND PRIX GTP, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (BODY CONTROL MODULE)DIAGNOSIS & REPAIRDTC U1064, LOSS OF BCM SOURCE ID 40TESTING
1997 Pontiac Grand Prix GTP, 4D Sedan

DTC U1064, Loss Of BCM Source Id 40: Testing

1997 Pontiac Grand Prix GTP, 4D SedanSECTION Testing
WARNING: This page is about a different car, the 1997 Buick Regal and 1997 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. If BCM diagnostic system check was performed, go to next step. If BCM diagnostic system check was not performed, go to BCM DIAGNOSTIC SYSTEM CHECK  .
  2. Turn ignition on. Clear DTCs. Check for DTCs. If DTC U1064 sets again, go to next step. If DTC U1064 does not set again, system is operating properly.
  3. Turn ignition off. Replace BCM. See REMOVAL & INSTALLATION  . Reprogram BCM. See BCM PROGRAMMING. Go to next step.
  4. Turn ignition off. Reinstall all components and connectors. Turn ignition on. Using scan tool, clear DTCs. Perform BCM DIAGNOSTIC SYSTEM CHECK  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.