Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1997GRAND PRIX GTP, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (BODY CONTROL MODULE)DIAGNOSIS & REPAIRDTC B2805, RFA PROGRAMMING/DIAGNOSTIC MODE MESSAGE NOT RECEIVEDTESTING
1997 Pontiac Grand Prix GTP, 4D Sedan
DTC B2805, RFA Programming/Diagnostic Mode Message Not Received: Testing
1997 Pontiac Grand Prix GTP, 4D SedanSECTION Testing
WARNING: This page is about a different car, the 1997 Buick Regal and 1997 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- If BCM diagnostic system check was performed, go to next step. If BCM diagnostic system check was not performed, go to BCM DIAGNOSTIC SYSTEM CHECK .
- Turn ignition off. Attempt to enable transmitter programming/diagnostic mode. See appropriate REMOTE KEYLESS ENTRY SYSTEM article. If transmitter programming/diagnostic mode can be entered, go to next step. If transmitter programming/diagnostic mode cannot be entered, go to step 4).
- Exit transmitter programming/diagnostic mode by turning ignition switch to RUN position. Using scan tool, clear DTCs. Turn ignition off. Enable transmitter programming/diagnostic mode again. Check for DTCs. If DTC B2805 sets again, go to step 5). If DTC B2805 does not set again, system is operating properly.
- Using Remote Keyless Entry (RKE) transmitter, attempt to lock and unlock doors. If doors lock and unlock, go to step 7). If doors do not lock and unlock, go to step 6).
- Turn ignition off. Replace BCM. See REMOVAL & INSTALLATION . Reprogram BCM. See BCM PROGRAMMING. Go to step 7).
- Using Device Control function on a Tech 2 scan tool, activate RFA link output. Using DVOM, check voltage between ground and BCM 32-pin connector C1 terminal C15 (Black wire). If reading is less than 2 volts, go to step 8). If reading is not less than 2 volts, go to step 5).
- Turn ignition off. Reinstall all components and connectors. Turn ignition on. Using scan tool, clear DTCs. Perform BCM DIAGNOSTIC SYSTEM CHECK .
- Check for poor connections at RCDLR. If connections are okay, replace RCDLR. Go to step 7).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.