Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1997GRAND PRIX GTP, 4D SEDANREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (BODY CONTROL MODULE)DIAGNOSIS & REPAIRDTC B0807, BATTERY FOR DOOR LOCK CIRCUIT (OPEN)TESTING
1997 Pontiac Grand Prix GTP, 4D Sedan
DTC B0807, Battery For Door Lock Circuit (Open): Testing
1997 Pontiac Grand Prix GTP, 4D SedanSECTION Testing
WARNING: This page is about a different car, the 1997 Buick Regal and 1997 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- If BCM diagnostic system check was performed, go to next step. If BCM diagnostic system check was not performed, go to BCM DIAGNOSTIC SYSTEM CHECK .
- Check DOOR LOCKS fuse (20-amp), located in instrument panel fuse block. If fuse is okay, go to next step. If fuse is blown, go to step 4).
- Turn ignition off. Disconnect BCM 10-pin connector C3. Using test light, backprobe between ground and BCM harness connector C3 terminal "J" (Orange wire). If test light illuminates, go to step 5). If test light does not illuminate, go to step 6).
- Turn ignition off. Disconnect BCM 10-pin connector C3. Using test light, backprobe between battery voltage and BCM harness connector C3 terminal "H" (Tan wire). If test light illuminates, go to step 9). If test light does not illuminate, go to step 10).
- Turn ignition off. Reinstall all components and connectors. Using scan tool, clear DTCs. Check for DTCs. If DTC B0807 sets again, go tostep 7). If DTC B0807 does not set again, system is operating properly.
- Repair poor connection or open in Orange wire between BCM connector C3 and instrument panel fuse block. Go to step 8).
- Turn ignition off. Replace BCM. See REMOVAL & INSTALLATION . Reprogram BCM. See BCM PROGRAMMING. Go to step 8).
- Turn ignition off. Reinstall all components and connectors. Turn ignition on. Using scan tool, clear DTCs. Perform BCM DIAGNOSTIC SYSTEM CHECK .
- Repair short to ground in Tan wire between appropriate door lock and BCM connector C3. Replace DOOR LOCKS fuse. Go to step 8).
- Repair short to ground in Gray wire between appropriate door lock and BCM connector C3. Replace DOOR LOCKS fuse. Go to step 8).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.