Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1997GRAND PRIX GTP, 4D SEDANREPAIR AND DIAGNOSISBODY & FRAMEBODY, CAB CONTROL SYSTEMSBODY CONTROL MODULESELF-DIAGNOSTIC SYSTEMINPUT/OUTPUT DIAGNOSTICS
1997 Pontiac Grand Prix GTP, 4D Sedan
Input/Output Diagnostics
1997 Pontiac Grand Prix GTP, 4D SedanSECTION Input/Output Diagnostics
- After all DTCs have been displayed, BCM provides individual input and output diagnostic checks for all functions. All systems (except interior lights, tamper signal and RKE input) will indicate each change in system status (i.e., driver's door opened) with a single flash and chime bong. If the proper feedback is not received, then there is an open or short in that circuit or a faulty component.
- RKE input is tested when diagnostics is entered. BCM sends a signal to Remote Control Door Lock Receiver (RCDLR), and will setDTC 8 if a signal is not returned.
- To test interior lights and tamper signal, change interior light switch from an inactive to an active state to allow BCM to go through cycles. See INTERIOR LIGHTS/TAMPER SIGNAL INPUT/OUTPUT DIAGNOSTIC table. Each time interior lights change from an inactive to an active state, BCM goes to next cycle and chime bongs to let technician know what cycle BCM is in.
INTERIOR LIGHTS/TAMPER SIGNAL INPUT/OUTPUT DIAGNOSTIC
| Cycle No. | Action | ||||
|---|---|---|---|---|---|
| 1 | Battery Output To Courtesy Lights Deactivated | ||||
| 2 | Battery Output To Courtesy Lights Activated | ||||
| 3 | (1) If Mileage Flag Is Set, Courtesy Output Is Inactive, Then Activated For One Second | ||||
| 4 (2) | Exterior Lights Activated For One Second | ||||
| 5 (2) | Horn Activated For 0.5 Second | ||||
| 6 (2) | Shock Sensor Diagnostics Enabled & Security Warning Indicator Turned On | ||||
| 7 (2) | Shock Sensor Diagnostics Disabled & Security Warning Indicator Turned Off | ||||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.