Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1997GRAND PRIX GTP, 4D SEDANREPAIR AND DIAGNOSISBODY & FRAMEBODY, CAB CONTROL SYSTEMSBODY CONTROL MODULESELF-DIAGNOSTIC SYSTEMENTERING DIAGNOSTICS
1997 Pontiac Grand Prix GTP, 4D Sedan
Entering Diagnostics
1997 Pontiac Grand Prix GTP, 4D SedanSECTION Entering Diagnostics
- Remove MALL PGM (10-amp) fuse from instrument panel fuse block. Turn ignition switch to ACC position. Seat belt indicator and chime will activate 2-4 times to indicate which type of BCM is used in vehicle. Ensure installed BCM is compatible with features available on vehicle. Replace BCM if necessary.
- At this time, vehicle is now in feature customization mode. Turn ignition switch to LOCK, then to ACC position within one second. Diagnostic Trouble Codes (DTCs) may flash and chime simultaneously from 1-8 times. See BCM DTC DEFINITION . If more than one DTC exists, codes will be flashed in sequence with a 2-second pause between codes. DTCs will repeat 3 times.
- DTCs will be stored for 10 years unless they are erased. Record any existing DTCs, then press and hold any door unlock switch for 4 seconds to erase DTCs. Exit diagnostics. See EXITING DIAGNOSTICS .
- Operate function(s) that set DTC. Re-enter diagnostics, and check if any DTCs exist. If any DTCs exist, perform appropriate test under DIAGNOSIS & REPAIR .
- If diagnostics cannot be accessed, try entering diagnostics again. If diagnostics still cannot be entered, see CANNOT ENTER DIAGNOSTICS under DIAGNOSIS & REPAIR.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.