Buzzers, Relays & Timers

1997 Pontiac Grand Prix GTP, 4D SedanSECTION Buzzers, Relays & Timers
BUZZERS, RELAYS & TIMERS

Component Component Location
A/C CLU Relay In underhood electrical center.
Air Pump Relay In underhood electrical center.
Accessory Time Delay (RAP) Relay Behind right side of dash, mounted to underside of cross car beam. See Figure .
Blower Motor Relay Integral with blower motor resistor.
Cooling Fan Motor Relays (1, 2, 3) In underhood electrical center.
Crank Relay In underhood electrical center.
Door Lock Relay Behind dash, mounted to cross car beam.
Electronic Brake Control Relay Below left side of dash, mounted to multi-purpose bracket. See Figure .
F/PMP SPD CONT Relay In underhood electrical center.
Fog Lamp Relay In underhood electrical center.
Fore/Aft Lumbar Adjuster Relay Below driver seat. See Figure .
Fuel Pump Relay In underhood electrical center.
Hazard Lamp & Turn Signal Lamp Flasher Below left side of dash, mounted on multi-purpose bracket, near BCM. See Figure .
Horn Relay In underhood electrical center.
IGN Main Relay In underhood electrical center.
Rear Compartment Lid Release Relay Below left side of dash, mounted on BCM mounting bracket. See Figure .
Rear Window Defogger Relay Behind right side of dash, mounted on underside of cross car beam See Figure .
Theft Deterrent Relay Behind left side of dash, mounted on BCM mounting bracket.
Up/Down Lumbar Adjuster Relay Below driver seat.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.