Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Shock Sensor Diagnostics
When shock sensor is enabled during cycle No. 6 in INTERIOR LIGHTS/TAMPER SIGNAL INPUT/OUTPUT DIAGNOSTICS table under INPUT/OUTPUT DIAGNOSTICS, BCM-4 will activate horn output upon detection of an inactive to active transition on tamper input. While vehicle is in this cycle, technician is able to test tamper input anywhere on vehicle.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.