Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 48, Mass Airflow Sensor: Notes
Mass airflow meter measures amount of induction airflow. This information is used by PCM to determine adjustments to air/fuel ratio. MAF sensor is a hot-wire type. Sensor maintains hot wire at a predetermined temperature. The greater the airflow across the hot wire, the more current is required to maintain hot wire temperature. Sensor changes the current requirements into a frequency signal which is read by the PCM. The PCM calculates airflow based upon this signal.
- Determines if fault is a hard failure or an intermittent condition.
- Checks for 5-volt reference from PCM.
- Verifies both ignition voltage and a good ground circuit are available.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.