Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1991TRANS SPORT SE, 3T40/MD9REPAIR AND DIAGNOSISSTEERINGPOWER STEERINGSTEERING SYSTEM - POWERREMOVAL & INSTALLATIONBOOTREMOVAL
1991 Pontiac Trans Sport SE, 3T40/MD9
Removal & Installation: Boot: Removal
1991 Pontiac Trans Sport SE, 3T40/MD9SECTION Removal
Remove outer tie rod end. See OUTER TIE ROD END removal and installation. Remove lock nut for outer tie rod from inner tie rod. Remove boot clamps and boot.
CAUTION:
Mark location of breather tube on housing for reassembly reference before removing boot. See Figure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.