Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1991TRANS SPORT SE, 3T40/MD9REPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGMANUAL STEERINGSTEERING SYSTEM - POWEROVERHAULINNER TIE ROD ENDDISASSEMBLY
1991 Pontiac Trans Sport SE, 3T40/MD9
Inner Tie Rod End: Disassembly
1991 Pontiac Trans Sport SE, 3T40/MD9SECTION Disassembly
- Remove steering gear and boot. See STEERING GEAR and BOOT removal and installation in this article. Remove shock damper ring from inner tie rod.
- Place wrench on flat area of rack assembly and wrench on flat of inner tie rod housing. See Fig 1. Rotate inner tie rod housing counterclockwise and separate inner tie rod from the rack.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.