Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1991FIREBIRD FORMULA, 5.0 F, STANDARD, M39REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (ENGINE CONTROLS - BASIC TESTING)BASIC FUEL SYSTEM CHECKS (A-7)FUEL SYSTEM PRESSURE TEST (SATURN)FUEL PRESSURE RELIEF (TBI & PFI)
1991 Pontiac Firebird Formula, 5.0 F, Standard, M39
Fuel Pressure Relief (TBI & PFI)
1991 Pontiac Firebird Formula, 5.0 F, Standard, M39SECTION Fuel Pressure Relief (TBI & PFI)
WARNING: This page does not describe the selected car, but rather 39 other vehicles, including the 1992 Saturn SL2, 1992 Saturn SL1, 1992 Saturn SL, 1992 Saturn SC, and 1992 Pontiac Sunbird. However, it is still accessible from the selected car via links, so may be relevant.
Fuel pressure may be relieved by using one of the following methods.
- Disconnect fuel pump at rear body connector. Start engine and run engine until it stalls. Crank starter for 3 seconds to remove remaining fuel from fuel lines. Reconnect rear body connector.
- Install Fuel Pressure Gauge (SA9127E1) on fuel pressure connector fitting at rear of engine. Wrap shop towel around pressure connection when installing fuel pressure gauge to absorb fuel leakage. Install gauge bleed hose in container. Open bleed valve to bleed fuel pressure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.