Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1990FIREBIRD TRANS AM, 5.0 F, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES (RWD))ALIGNMENT SPECIFICATIONSWAGON
1990 Pontiac Firebird Trans Am, 5.0 F, Standard
Alignment Specifications: Wagon
1990 Pontiac Firebird Trans Am, 5.0 F, StandardSECTION Wagon
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 1990 Oldsmobile Custom Cruiser, 1990 Chevrolet Caprice, 1990 Buick Estate Wagon, 1989 Pontiac Safari, and 1989 Oldsmobile Custom Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
WHEEL ALIGNMENT SPECIFICATIONS (WAGON)
| Application | Preferred | Range |
|---|---|---|
| Camber (Degrees) Front | 13/16 | 0 to 1 5/8 |
| Camber (Degrees) Rear | N/A | N/A |
| Caster (Degrees) Front | 2 13/16 | 1 13/16 to 3 13/16 |
| Caster (Degrees) Rear | N/A | N/A |
| Toe-In (Inches) Front | 1/16 | -1/32 to 5/32 |
| Toe-In (Inches) Rear | N/A | N/A |
| Toe-In (Millimeters) Front | 1.6 | -.8 to 4.0 |
| Toe-In (Millimeters) Rear | N/A | N/A |
| Toe-In (Degrees) Front | 1/8 | -1/16 to 5/16 |
| Toe-In (Degrees) Rear | N/A | N/A |
| Steering Axis Inclination (SAI) | 10 13/16° | N/A |
| Wheelbase (Inches) | 115.9 | N/A |
| Wheelbase (Millimeters) | 2944 | N/A |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.