Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC19906000 LE, 4D SEDAN, 2.5 RREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - BASIC TESTINGNO START DIAGNOSISNO START - ENGINE CRANKS OKAY (TBI WITH DIS)FUEL SYSTEM
1990 Pontiac 6000 LE, 4D Sedan, 2.5 R
Fuel System
1990 Pontiac 6000 LE, 4D Sedan, 2.5 RSECTION Fuel System
- Prior to checking fuel system for a no-start condition, check ignition for adequate spark. Check for proper fuel pump pressure (9-13 psi for all models except 2.8L W Body and 26-32 psi for 2.8L W Body) and capacity (one pint in 30 seconds). See BASIC FUEL SYSTEM CHECKS in this article.
- Crank engine and watch for injector spray. If injector spray occurs, go to step 5). If no spray occurs, disconnect injector harness and check for battery voltage at harness with ignition on. Battery voltage should be present on the Red or Pink/Black wire of the injector harness. If battery voltage is not present, check for blown injector power fuse. If battery voltage is present on both injector harness terminals, check for wires shorted to one another.
- If battery voltage is present on only one terminal, connect injector test light to injector harness. Crank engine and note light. If light flashes, check for stored ECM codes. If no codes are present, refer to HARD START symptom in TESTS W/O CODES article. If light does not flash, momentarily touch test light connected to battery voltage to ECM RPM reference terminal (circuit No. 430). See Fig 1 -11.
- Each time test light is removed from ECM RPM reference terminal, injector test light should flash. If test light does not flash, check for open in RPM reference wire, injector drive (ground) circuit, or replace faulty ECM.
- If injector spray occurred while cranking engine, disconnect injector harness and crank engine. If injector spray or leakage occurs this could cause a no-start condition due to excessive fuel being delivered during cranking. Repair faulty injector or injector seal. If no spray or leakage occurs, refer to HARD START symptom in appropriate TESTS W/O CODES article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.