Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC19906000 LE, 4D SEDAN, 2.5 RREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - BASIC TESTINGBASIC IGNITION SYSTEM CHECKSHEI-EST DISTRIBUTORIGNITION COIL POWER SOURCE
1990 Pontiac 6000 LE, 4D Sedan, 2.5 R
Ignition Coil Power Source
1990 Pontiac 6000 LE, 4D Sedan, 2.5 RSECTION Ignition Coil Power Source
- Turn ignition on. Using voltmeter, check voltage between terminal "B" of ignition coil and ground on models with remote-mounted coil.
- On models equipped with integral ignition coil, check voltage between "BAT" terminal and ground at distributor. Battery voltage should exist. If not, check for open circuit, blown ignition fuse or defective ignition switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.