Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1989GRAND PRIX V6-191 3.1LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINS
1989 Pontiac Grand Prix V6-191 3.1L
Computers and Control Systems: Technical Service Bulletins
1989 Pontiac Grand Prix V6-191 3.1LSECTION Technical Service Bulletins
- Customer Interest
- By Symptom
- All Technical Service Bulletins
- Engine - THIS BULLETIN HAS BEEN CANCELED
- Electrical - MIL ON/DTC's Set By Various Control Modules
- Electrical - Intermittent MIL/DTC P2138/Reduced Power
- Engine, A/T - Shift/Driveability Concerns/MIL ON
- A/T - Intermittent TCC, MIL ON, and DTC 62/26 Set
- Engine Controls - Incorrect Bulletin Reference Numbers
- Engine - Stall on Start Up
- Engine Controls - Revised Chart C8, TCC Operation
- Engine Controls - Revised Charts C-8A and C-8C (TCC)
- Oxygen Sensor Test - Revised Tech 1 Mass Storage CD
- No MIL Diagnostic Chart A-1 Revision
- ECM/PCM - Damaged and/or Mis-Diagnosed
- ECM/PCM - Circuit Board Damage Prevention
- Code 43 - Driveability and Emissions Manual Update
- Engine Controls - MAP Chart, DTC's 33, 34 ,63 ,64
- Tech 1 ECM Cartridge - Usage
- Engine Controls - Static Electrical Damage Precaution
- Crank Sensor - Revised Voltage Output Specifications
- TPS - Replacement and Testing Information
- Engine Controls - Revised Chart C-2B and Code 44
- Engine Controls - Start & Stall or Starting Problem, IAC
- ECM - Packard 32 Way Connector Identification
- ECM - Packard 32-Way Connector Identification
- Oxygen Sensors - Silica Contamination
- Vehicle Speed Sensor - Revised Diagnostic Information
- Engine Controls - Updated Vehicle Speed Sensor Test
- Engine Controls - Crankshaft Sensor R&R Precautions
- Tools - IAC Driver Use Instructions
- PROM/MEMCAL - Identification Marks
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.