Wheel Bearing: Remove & Replace

1987 Pontiac Firebird Trans Am, 5.0 H, AutomaticSECTION Remove & Replace
WARNING: This page is about the Firebird Base, 2.8 S, Automatic, which is a different variant/trim than selected.
Includes: Replace Inner and/or Outer Bearings, Cups, Seals and repack (where applicable).

Applies ToNoteStandard HoursWarranty HoursSkill Level
RWD, Rear,w/C-Lock Axle,Both1.50.8B
RWD, Rear,w/C-Lock Axle,One Side1.00.7B
RWD, Rear,w/o C-Lock Axle,Both1.41.0B
RWD, Rear,w/o C-Lock Axle,One Side0.80.6B
Front,Both2.0B
Front,One Side1.0B
Additional Procedure: WHEEL BEARING: Remove & Replace:
Both,w/Rear Disc Brakes add0.8B
One Side,w/Rear Disc Brakes add0.5B
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.