Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1984FIERO BASE, STANDARD, MY8REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMEARLY FUEL EVAPORATION SYSTEMCOMPONENT TESTINGVACUUM SERVO QUICK CHECK
1984 Pontiac Fiero Base, Standard, MY8
Vacuum Servo Quick Check
1984 Pontiac Fiero Base, Standard, MY8SECTION Vacuum Servo Quick Check
NOTE:
Before performing EFE test, allow engine coolant temperature to cool to below 40°F (4°C).
- Locate EFE valve and note position of actuator arm. On some V8 engines, EFE valve actuator arm is protected by a 2-piece metal cover, which must be removed and then replaced after service has been performed.
- Valve should close when engine is started cold. Actuator link will be pulled into diaphragm housing. If valve does not close, stop engine and remove vacuum hose from EFE valve.
- Using a hand vacuum pump, apply at least 10 in. Hg of vacuum. Valve should close and remain closed for at least 20 seconds without applying additional vacuum. Replace valve if leakdown time is less than 20 seconds.
- If valve does not close, lubricate valve with manifold heat valve lubricant (1050422). Replace valve if necessary. If valve did not close when vacuum was applied and valve is not seized, vacuum diaphragm is defective. Replace EFE valve.
- If valve closed, problem is not in EFE valve. Check for loose, kinked, pinched or plugged vacuum hoses or connections. Also check EFE-TVE, EFE-TVV or EFE solenoids.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.