Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC19846000 STEREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONFRONT SUSPENSIONSUSPENSION - FRONTREMOVAL & INSTALLATIONSTRUT ASSEMBLYDISASSEMBLY
1984 Pontiac 6000 STE
Strut Assembly: Disassembly
1984 Pontiac 6000 STESECTION Disassembly
- Mount strut in compressor using bottom adapter (J-26584-400 ) on "A" and "X" bodies and J-26584-86 on "J" bodies). Install top adapter (J-26584-430 on "A" and "X" bodies and J-26584-88 on "J" bodies). Compress strut spring about 1/2".
- Remove top nut from strut damper shaft. Use alignment rod (J-34013-27 ) to guide damper shaft through spring cap while decompressing spring. Remove strut assembly from compressor tool. Remove strut mounting assembly, spring shield, strut bumper and spring. See Figure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.