Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1983GRAND PRIX BASE, 5.0 HREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES)ADJUSTMENTSTOE-IN ADJUSTMENTFRONT WHEELS
1983 Pontiac Grand Prix Base, 5.0 H
Front Wheels
1983 Pontiac Grand Prix Base, 5.0 HSECTION Front Wheels
WARNING: This page is about a different car, the 1983 Pontiac Firebird and 1983 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
Toe-in can be changed by changing the length of tie rods. When tie rods are mounted ahead of steering knuckle they must be decreased in length in order to increase toe-in.
- Loosen clamp bolts at each end of steering tie rod adjustment sleeve. On models with rack and pinion steering loosen jam nut. With steering wheel set in straight ahead position, turn tie rod adjusting sleeves to obtain the proper toe-in adjustment.
- When adjustment is completed, check to see that the number of threads showing on each end of sleeve are equal and that tie rod end housing are at right angles to steering arm. Position tie rod clamps and sleeves. See Fig 1 . Tighten to specifications. On rack and pinion models tighten jam nut when set to proper specifications.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.