Scan Tool Screen Blank (Help 1)

1997 Plymouth Prowler V6-3.5L VIN FSECTION Scan Tool Screen Blank (Help 1)

Data Link Connector Identification:






NOTE: Ensure the scanner is properly connected, before proceeding.

If The Screen Is Still Blank, Perform The Following Procedure:

a. Check all cable connectors for spread terminals, proper seating, and a snug fit.
b. Check scan tool cables for broken insulation and shorted wires.
c. Check scan tool cartridge and cartridge installation.
d. Check scan tool operation on another vehicle.

- If the scan tool screen is still blank, have the unit repaired.

On-Board Diagnostic Connector Identification (Wire Color May Vary By Model):






- If it now performs properly, check power and ground to the data link connector of problem vehicle.



RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.