Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1997PROWLER V6-3.5L VIN FREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORSERVICE AND REPAIR
1997 Plymouth Prowler V6-3.5L VIN F
Crankshaft Position Sensor: Service and Repair
1997 Plymouth Prowler V6-3.5L VIN FSECTION Service and Repair
Crankshaft Position Sensor:
The crankshaft sensor is located on the passengers side of the engine bell housing. The bottom of the sensor sits above the drive plate.
REMOVAL
1. Raise and support vehicle.
2. Disconnect electrical connector from crankshaft position sensor.
3. Remove sensor mounting screw. Remove sensor.
INSTALLATION
1. Reverse procedure for installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.