Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994SUNDANCE BASE, 2D HATCHBACK, 2.2 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 21 (ANTI-LOCK BRAKE SYSTEM)CONNECTOR IDENTIFICATION
1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, Automatic
Connector Identification
1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, AutomaticSECTION Connector Identification
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
CONNECTOR IDENTIFICATION DIRECTORY
| Connector | Figure |
|---|---|
| ABS Relay | Fig. Fig 1 |
| Brake Fluid Level Switch No. 1 | Fig. Fig 2 |
| Brake Fluid Level Switch No. 2 | Fig. Fig 3 |
| CCD Data Link | Fig. Fig 4 |
| Controller Anti-Lock Brake (CAB) | Fig. Fig 5 |
| Electronic Message Center | Fig. Fig 6 |
| Mechanical Message Center | Fig. Fig 7 |
| Pedal Travel Sensor | Fig. Fig 8 |
| Pump/Motor (Harness End) | Fig. Fig 9 |
| Pump/Motor Relay | Fig. Fig 10 |
| Traction Control System Switch | Fig. Fig 11 |
| Wheel Speed Sensors | Fig. Fig 12 |
ABS RELAY CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| A (86) | WHT | Ignition Switch Output |
| B (30) | BRN/WHT | Relay Output |
| C (85) | ORG/BLK | Relay Control |
| D (87) | RED/DK GRN | Fused Battery Feed |
| E (87a) | BLK | Ground |
BRAKE FLUID LEVEL SWITCH NO. 1 CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | BLK | Ground |
| 2 | GRY/BLK | Brake Warning Light Driver |
BRAKE FLUID LEVEL SWITCH NO. 2 CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | DK GRN/WHT | Ground |
| 2 | DK BLU/WHT | Signal |
CCD DATA LINK CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | LT GRN | SCI Receive |
| 2 | PNK | Battery Positive Voltage |
| 3 | WHT/BLK | CCD Bus (-) |
| 4 | VIO/BRN | CCD Bus (+) |
| 5 | PNK | SCI Transmit |
| 6 | BLK/LT GRN | Ground |
CONTROLLER ANTI-LOCK BRAKE (CAB) CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | WHT | RF WSS (+) |
| 2 | Not Used | |
| 3 | GRY | Pump/Motor Relay Control |
| 4 | LT BLU/BLK | LTCS Warning Light Driver |
| 5 | VIO/BRN | CCD Bus (+) |
| 6 | WHT/DK BLU | RF WSS (-) |
| 7 | RED/DK GRN | Fused Battery Feed |
| 8 | VIO/WHT | Pump/Motor Speed Sensor (+) |
| 9 | RED/YEL | LTCS Switch Sense |
| 10 | RED/WHT | Pedal Travel Sensor Signal |
| 11 | BLK | Ground |
| 12 | BLK | Ground |
| 13 | BRN/WHT | ABS Main Relay Output |
| 14 | Not Used | |
| 15 | RED | LF WSS (+) |
| 16 | LT GRN/ORG | ABS Amber Light Driver |
| 17 | DK GRN/WHT | Low Brake Fluid Sw. 2 Ground |
| 18 | GRY/BLK | Red Brake Light Driver |
| 19 | LT GRN/DK BLU | LR WSS (-) |
| 20 | GRY/BLK | LTCS Active Light Driver |
| 21 | YEL/WHT | Pump/Motor Speed Sensor (-) |
| 22 | WHT/TAN | Stoplight Switch Output |
| 23 | Not Used | |
| 24 | BLK | Ground |
| 25 | BRN/WHT | ABS Main Relay Output |
| 26 | Not Used | |
| 27 | WHT/BLK | CCD Bus (-) |
| 28 | LT GRN | LR WSS (+) |
| 29 | YEL | RR WSS (+) |
| 30 | RED/DK BLU | LF WSS (-) |
| 31 | YEL/DK BLU | RR WSS (-) |
| 32 | ORG/BLK | ABS Main Relay Control |
| 33 | WHT | Fused Ignition Feed |
| 34 | Not Used | |
| 35 | DK BLU/WHT | Low Brake Fluid Sw. |
| 36 | PNK | Pedal Travel Sensor Ground No. 2 |
| 37 | BRN/WHT | ABS Main Relay Output |
ELECTRONIC MESSAGE CENTER CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | PNK/BLK | Door Ajar Light Driver |
| 2 | GRY/BLK | TLCS Active Light Driver |
| 3 | LT BLU/BLK | TLCS Warning Light Driver |
| 4 | DK BLU/WHT | Fused Ignition Feed |
| 5 | Not Used | |
| 6 | RED | Washer Fluid Light Driver |
| 7 | PNK | Fused Battery Feed |
| 8 | LT GRN/ORG | ABS Warning Light Driver |
| 9 | TAN/BLK | Trunk Ajar Switch Sense |
MECHANICAL MESSAGE CENTER CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | ORG | Cluster Illumination |
| 2 | Not Used | |
| 3 | BLK | Ground |
| 4 | LT GRN | Left Turn Signal |
| 5 | GRY | Oil Pressure Switch Sense |
| 6 | GRY/BLK | Red Brake Warning Light Driver |
| 7 | Not Used | |
| 8 | RED/ORG | Hi Beam Indicator Light Feed |
| 9 | Not Used | |
| 10 | BLK/TAN | Air Bag Warning Light Driver |
PEDAL TRAVEL SENSOR CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | RED/WHT | Sensor Signal |
| 2 | PNK | Sensor Ground |
PUMP/MOTOR CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | BLK | Ground |
| 2 | BRN/WHT | ABS Pump/Motor Relay Output |
| 3 | VIO/WHT | Pump Speed Sensor (+) |
| 4 | YEL/WHT | Pump Speed Sensor (-) |
PUMP/MOTOR RELAY CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| A | GRY | Relay Control |
| B | BRN/WHT | Relay Output |
| C | BRN/WHT | ABS Main Relay Output |
| D | DK BLU | Fused Battery Feed |
TRACTION CONTROL SYSTEM SWITCH CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | BLK | Ground |
| 2 | RED/YEL | TLCS Switch Sense |
| 3 | ORG | H/L Switch Dim Light |
| 4 | DK GRN | RF Keyless Program Enable |
| 5 | Not Used | |
| 6 | Not Used |
LEFT FRONT WHEEL SPEED SENSOR CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | RED/DK BLU | Sensor (-) |
| 2 | RED | Sensor (+) |
LEFT REAR WHEEL SPEED SENSOR CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | LT GRN/DK BLU | Sensor (-) |
| 2 | LT GRN | Sensor (+) |
RIGHT FRONT WHEEL SPEED SENSOR CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | WHT/DK BLU | Sensor (-) |
| 2 | WHT | Sensor (+) |
RIGHT REAR WHEEL SPEED SENSOR CONNECTOR
| Terminal | Wire Color | Function |
|---|---|---|
| 1 | YEL/DK BLU | Sensor (-) |
| 2 | YEL | Sensor (+) |
BRAKELIGHT SWITCH CONNECTOR
| Terminal | Wire Color | Function | ||
|---|---|---|---|---|
| 1 | YEL/RED | Ignition 12-Volt Feed | ||
| 2 | WHT/TAN | (1) | ||
| 3 | WHT/PNK | Brake Switch Sense | ||
| 4 | DK BLU/RED | Speed Control Relay Output | ||
| 5 | PNK/DK BLU | Battery (+) Voltage | ||
| 6 | BLK/LT GRN | System Ground | ||
|
||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.