Identifying Vehicle Equipment & System Problems

1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, AutomaticSECTION Identifying Vehicle Equipment & System Problems
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect DRB to data link (diagnostic) connector. See Figure . If DRB is not operational, see DRB PROBLEMS & ERROR MESSAGESΒ  .
  2. Turn ignition switch to ON position. Set DRB to BODY SYSTEM mode and read display. If DRB does not display BUS OPERATIONAL, see BLANK DRB SCREEN under DRB PROBLEMS & ERROR MESSAGESΒ  . Select BODY CONTROL mode. If DRB does not display NO RESPONSE, go to REPAIRING MANUAL A/C SYSTEM. If DRB displays NO RESPONSE, go to NO RESPONSE MESSAGE under DRB PROBLEMS & ERROR MESSAGESΒ  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.