Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994SUNDANCE BASE, 2D HATCHBACK, 2.2 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (INSTRUMENT PANEL (CONVERTIBLE))REMOVAL & INSTALLATIONHEADLIGHT SWITCHINSTALLATION
1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, Automatic
Headlight Switch: Installation
1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, AutomaticSECTION Installation
WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
- Position switch linkage in upward position. Install dimmer shaft in dimmer knob while aligning headlight switch to switch pod mounting position.
- Release switch linkage, and install it onto switch control push buttons. Check headlight switch control buttons for proper operations. Install turn signal switch to switch pod. Install turn signal lever by pressing straight through switch pod opening and into turn signal switch. To install remaining components, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.