SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994SUNDANCE BASE, 2D HATCHBACK, 2.2 D, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 11 (ENGINE CONTROLS - TESTS W/CODES - BODY CONTROL COMPUTER)DESCRIPTION
1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, Automatic

Section 11 (Engine Controls - Tests W/Codes - Body Control Computer): Description

1994 Plymouth Sundance Base, 2D Hatchback, 2.2 D, AutomaticSECTION Description
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

The body control computer system consists of a combination of modules that communicate over the Chrysler Collision Detection (CCD) bus system. Through the CCD bus, information related to the operation of vehicle components and circuits is relayed to the appropriate system module(s). Each module receives the same information about a component. This reduces the complexity of vehicle wiring and size of wiring harness.

Body control computer systems covered in this article and BODY CONTROL COMPUTER TESTS are as follows: automatic door locks, chime functions, compass/temperature module, courtesy lights, door ajar system, electronic instrument cluster, Electronic Vehicle Information Center (EVIC), headlight doors, headlight time delay, illuminated entry system, intermittent wipers, (ignition) key-in light system, mechanical instrument cluster (warning lights), message center, Overhead Travel Information System (OTIS), Remote Keyless Entry (RKE) system and travel module.

Using Chrysler's Diagnostic Readout Box (DRB), body fault codes are accessed through CCD bus Data Link Connector (DLC). DLC is located under left side of dash or next to center console. See Fig 1 .

Fig 1: Locating Data Link Connector
G93C28409Courtesy of CHRYSLER CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.