Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Switch Test
Remove control switch from trim panel. Using ohmmeter, check continuity of switch. See MASTER WINDOW SWITCH CONTINUITY or PASSENGER SIDE WINDOW SWITCH CONTINUITY and Fig 1 . Replace appropriate switch as necessary if switch continuity is not as specified.
| Switch Position | Check Continuity Between | |
|---|---|---|
| Normal Position | ||
| Driver's OFF | Pins 2, 3 & 6 | |
| Passenger's OFF | Pins 1, 3 & 4 | |
| Driver's UP | Pins 2 & 3; Pins 5 & 6 | |
| Passenger's UP | Pins 1 & 3; Pins 4 & 5 | |
| Driver's DOWN | Pins 2 & 5; Pins 3 & 6 | |
| Passenger's DOWN | Pins 1 & 5; Pins 3 & 4 | |
| Lock Position | ||
| Driver's OFF | Pins 2, 3 & 6 | |
| Passenger's OFF | Pins 1 & 4 | |
| Driver's UP | Pins 2 & 3; Pins 5 & 6 | |
| Passenger's UP | Pins 4 & 5 | |
| Driver's DOWN | Pins 2 & 5; Pins 3 & 6 | |
| Passenger's DOWN | Pins 1 & 5 | |
| Switch Position | Check Continuity Between |
|---|---|
| OFF | Pins 2 & 4; Pins 3 & 5 |
| UP | Pins 2 & 4; Pins 5 & 6 |
| DOWN | Pins 3 & 5; Pins 4 & 6 |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.