Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSPLYMOUTH1994LASER FWD L4-1997CC 2.0L DOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTEMISSION CONTROL SYSTEMSTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESSURGE, HESITATION, STALL ON ACCELERATION
1994 Plymouth Laser FWD L4-1997cc 2.0L DOHC
Surge, Hesitation, Stall on Acceleration
1994 Plymouth Laser FWD L4-1997cc 2.0L DOHCSECTION Surge, Hesitation, Stall on Acceleration
Engine hesitates or stumbles on acceleration, sometimes stalling. This condition can occur at any speed, but primarily from a stop. Vehicle may also experience a surge or rise and fall of engine speed at cruise or steady throttle.
POSSIBLE CAUSE ACTION
EGR malfunction Check EGR system in "Testing
flange gasket leaking, Procedures" in Emissions
excessive backpressure,
loose valve
Spark timing Check Spark Controls in
"Fuel Injection and Computerized
Engine Controls"
Air management valves Check Air Injection system in
"Testing Procedures" in Emissions
Hot air tube not connected Check inlet air temperature system (TAC)
to air cleaner, vacuum motor in "Testing Procedures" in Emissions
inoperative, air damper
door binding or not opening
Faulty canister purge Check Evaporative system in
liquid fuel in carbon canister "Testing Procedures" in Emissions
Ignition timing Check Ignition Timing in "Adjustment
Procedures" in Emissions
Restricted exhaust system Check Catalytic Converter system in
"Testing Procedure" in Emissions
Poor or contaminated fuel Recommend higher grade fuel
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.