Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994GRAND VOYAGER BASE, 31THREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONENGINE PERFORMANCEMAP - ENGINE PERFORMANCE & MAINTENANCEENGINE PERFORMANCE AND MAINTENANCECYLINDER HEAD ASSEMBLIES
1994 Plymouth Grand Voyager Base, 31TH
Cylinder Head Assemblies
1994 Plymouth Grand Voyager Base, 31THSECTION Cylinder Head Assemblies
NOTE:
A Cylinder Head Assembly is a cylinder head fitted with valves, associated springs, retainers, and on overhead camshaft cylinder heads (ORC), camshaft, camshaft bearings, lash adjusters, tappets and rockers.
| Condition | Code | Procedure |
|---|---|---|
| Adjustable valve lash is out of specification | B | Require repair |
| Combustion efficiency is reduced due to carbon deposits in the combustion chamber | 2 | Suggest repair |
| Combustion efficiency is reduced due to carbon deposits on the intake valve | 2 | Suggest repair |
| Internal component failure (any component) | A | Require repair or replacement of cylinder head assembly |
|
NOTE:
It is Required that all other failure-related components be inspected for cause and condition. Additional components or assemblies may be Suggested for repair or replacement, such as a water pump on a short block ( reason code 4, technician's recommendation based on substantial and informed experience ). For example: If there is a failed head gasket with an external coolant leak, in addition to Requiring replacement of the head gasket, inspection of the following for cause and condition is Required: Block, Cooling System, Cylinder Head. It may be suggested that additional inspections be performed, such as the other head gasket on a V -type engine.
|
||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.