Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994GRAND VOYAGER BASE, 31THREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSDOOR LOCKS & LIFTGATE RELEASE - POWERCOMPONENT TESTINGCIRCUIT BREAKER TEST
1994 Plymouth Grand Voyager Base, 31TH
Circuit Breaker Test
1994 Plymouth Grand Voyager Base, 31THSECTION Circuit Breaker Test
- Locate circuit breaker in fuse block module. Pull out slightly, but ensure circuit breaker terminals still contact terminals in fuse block module.
- Connect ground wire of voltmeter to good ground. With probe of voltmeter positive lead, check both terminals of circuit breaker for battery voltage. If only one terminal checks at battery voltage, circuit breaker is defective and must be replaced.
- If neither terminal shows battery voltage, check for an open or shorted circuit to circuit breaker. Service and repair as necessary, and test components.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.