Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994COLT VISTA SE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONMANUAL TRANSREMOVAL & INSTALLATION - M/TREMOVAL & INSTALLATIONTRANSAXLE - 2WD MODELSINSTALLATION (2WD)
1994 Plymouth Colt Vista SE, Standard
Installation (2WD)
1994 Plymouth Colt Vista SE, StandardSECTION Installation (2WD)
- Using clutch pilot, install pressure plate and clutch disc. Tighten bolts evenly in a crisscross pattern to specification. See TORQUE SPECIFICATIONS .
- Clean release bearing sliding surface. Apply multipurpose grease to release bearing sliding surface. Apply a light amount of grease to input shaft splines. DO NOT allow grease or dirt on clutch disc or pressure plate surfaces.
- To install remaining components, reverse removal procedure. Refill all fluids to proper levels. Adjust all control cables, clutch pedal height and free play.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.