Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1991LASER L4-1997CC 2.0L DOHCREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSERVICE AND REPAIRWITHOUT TILTDISASSEMBLY/ASSEMBLY
1991 Plymouth Laser L4-1997cc 2.0L DOHC
Disassembly/Assembly
1991 Plymouth Laser L4-1997cc 2.0L DOHCSECTION Disassembly/Assembly
1. Disable airbag, refer to Air Bags and Seat Belts/Air Bags (Supplemental Restraint Systems)/Service and Repair.
2. Remove steering column, refer to Removal/Installation.
3. Disassemble steering column in numbered sequence shown, noting the following:
- If it is necessary to remove the steering lock, use a hacksaw to cut the special bolts at steering lock bracket side.
4. Reverse procedure to install, noting the following:
- After ensuring steering lock operates correctly, tighten special bolts until heads twist off.
2. Remove steering column, refer to Removal/Installation.
Fig. 69 Exploded View Of Steering Column Assembly:
Fig. 70 Exploded View Of Steering Column Assembly:
Fig. 71 Steering Lock Removal:
Fig. 72 Lower Bearing Removal:
Fig. 73 Clevis Pin Removal:
3. Disassemble steering column in numbered sequence shown, noting the following:
- If it is necessary to remove the steering lock, use a hacksaw to cut the special bolts at steering lock bracket side.
Fig. 74 Column Tube Clamp Installation:
4. Reverse procedure to install, noting the following:
- After ensuring steering lock operates correctly, tighten special bolts until heads twist off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.