Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1990COLT L4-1468CC 1.5L SOHCREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSERVICE AND REPAIRWITHOUT TILTREMOVAL/INSTALLATION
1990 Plymouth Colt L4-1468cc 1.5L SOHC
Removal/Installation
1990 Plymouth Colt L4-1468cc 1.5L SOHCSECTION Removal/Installation
Fig. 10 Exploded View Of Steering Column Assembly:
Fig. 11 Exploded View Of Steering Column Assembly:
WARNING: On models equipped with Driver Airbag Restraint System, it is necessary to follow special procedures when servicing steering column components. These procedures are necessary to avoid accidental deployment of airbag which may cause damage or personal injury.
1. Refer to images above for steering column removal, noting the following:
a. Disconnect battery ground cable.
b. Remove trim clip (2) by lightly pushing pin at center of clip with a Phillips screwdriver, then pull out clip.
NOTE: Do not push pin in any further than necessary.
c. Remove steering wheel using a suitable puller.
CAUTION: Do not hammer on steering wheel to remove, as the collapsible mechanism may be damaged.
d. On Colt Wagon models, straighten claws of column switch (13), remove two attaching screws, then the column switch.
e. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.