Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1985CONQUEST L4-2555CC 2.6L SOHC TURBOREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGBLOWER MOTORSERVICE AND REPAIR
1985 Plymouth Conquest L4-2555cc 2.6L SOHC Turbo
Blower Motor: Service and Repair
1985 Plymouth Conquest L4-2555cc 2.6L SOHC TurboSECTION Service and Repair
Fig. 13 Blower Motor Replacement:
1. Disconnect battery ground cable.
2. Remove instrument panel under cover, then the glove box.
3. Disconnect blower motor electrical connector.
4. Remove blower motor attaching screws, then the blower motor.
5. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.