Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1984VOYAGER BASE, 2.2 C, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSREMOVAL & INSTALLATIONREAR WIPER MOTORNOTES
1984 Plymouth Voyager Base, 2.2 C, Automatic
Rear Wiper Motor: Notes
1984 Plymouth Voyager Base, 2.2 C, AutomaticSECTION Notes
- Install wiper arm removal tool (C 3982) on wiper arm. Lift arm and remove from output shaft. Unlock and open liftgate. Remove trim panel.
- Remove 4 rear wiper motor mounting screws. Disconnect wiring harness from rear motor connector and remove rear wiper motor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.